Specifications

ASMi-52 Installation and Operation Manual Appendix B IR-IP Interface Module
Using the Device Control Menu B-23
Resetting IR-IP
The Reset menu allows you to perform reset of IR-IP, or its interfaces.
This operation can be used to restore normal operation after service is disrupted
by an abnormal condition. Any data stored in the IR-IP buffers is discarded, and
the flow of traffic is temporarily interrupted.
IR_IP <IR-IP> S/W Ver. 1.21 (date)
Quick Setup
Management Access
Advanced Setup
Device Control
.....................................................................
New Software Download
View error LOG
Resets
=====================================================================
1. Reset Device
2. Reset LAN
3. Reset WAN
Press one of the numbers to select or ESC:
Figure B-17. Resets Menu

To restart IR-IP:
• From the Device Control menu, select Resets. From the Resets menu, type 1.
You will be prompted to confirm the reset operation.
Resetting the device will restart the IR-IP interface module, and therefore traffic flow
is temporarily interrupted, and the Telnet connection is lost.
Reset LAN

To reset the LAN interface:
• From the Resets menu, select Reset LAN.
You will be prompted to confirm the reset operation.
This operation restarts the IR-IP LAN controller.
To continue your Telnet session, press any key within 15 seconds following the
confirmation of the reset operation.
Reset WAN

To reset the WAN interface:
• From the Resets menu, select Reset WAN.
You will be prompted to confirm the reset operation.
Note
Note