Specifications
Chapter 6 Troubleshooting and Diagnostics ASMi-52 Installation and Operation Manual
6-20 Technical Support
ASMi-52
Repeater Test
1. RLB Network (ON)
2. Loop Timeout(min)[0 - 4095] ... (5)
3. Repeater number > (1)
4. Save
>
ESC-previous menu ; !–main menu ; &–exit
Figure 6-24. Repeater Test Menu
Deactivating the Loopbacks
To deactivate a running loopback:
• From the Local or Remote Test menu, type the number corresponding to the
loopback in progress to change its value from ON to OFF and choose Save.
The TST indicator turns off.
To deactivate multiple loopbacks:
• From the Local or Remote Test menu, select Clear All.
The TST indicator turns off.
Running the LEDs Test
The user can perform the front-panel LED test to verify that the local unit
indicators are functioning properly.
To run the LEDs test:
1. From the Diagnostics menu (see Figure 6-20), select Local Test to run the LEDs
test on the local ASMi-52.
The Local Test menu is displayed (see Figure 6-21).
2. Select LEDs Test.
All the front-panel LED indicators light up for two seconds.
6.5 Technical Support
Technical Support for this product can be obtained from the local distributor from
whom it was purchased.
For further information, please contact the RAD distributor
nearest you or one of
RAD's offices
worldwide.