Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Configuring for Operation 4-31
ASMi-52
T1 Local Port Configuration
Framed Mode >(SF)
Line code (B8ZS/AMI)
Receive Gain (LONG/SHORT)
Interface >(DSU/CSU)
Transmit Signal Mask (7.5 dB)
Fbit Configuration (Transparent/Internally Source)
Sync Mode (FAST)
Units identical setting (Yes/No)
Idle code (ff)
Time slots assign >
Save
>
ESC-prev. menu; !-main menu; &-exit;
Figure 4-31. T1 Port Configuration
Configuring the LAN Port
ASMi-52 includes a 10/100BaseT port that can be used as a user or management
port. The LAN port operates in a self-learning bridge or transparent mode, with
or without autonegotiation.
•
If the LAN port serves as a management port only, it operates in transparent
mode with autonegotiation enabled.
Configuring the LAN Port Operation Mode
In the transparent mode, the LAN port operates with a disabled filter, passing all
frames transparently. When operating as a self-learning bridge, the LAN port
filters the packets received from the local LAN and transfers through the link only
frames destined for another LAN.
³ To configure the LAN operation mode:
1. From the Operation Mode menu, select the Bridging Mode option (Main menu
> Configuration > LAN Configuration > Local LAN Configuration > Bridging
Mode) to enable bridge mode.
•
If LAN interface is used for data, the Operation Mode is set to Bridge. If Ethernet
is used for management purposes only, then the Operation Mode is permanently
set to Transparent.
The LAN Configuration menu appears.
2. From the LAN Configuration menu, select Save to save your changes.
Note
Note