Specifications

Chapter 4 Configuration Installation and Operation Manual
4-16 Configuring for Operation ASMi-52 Ver. 2.8
interface. The maximum data rate of ASMi-52 working in low speed mode is
2048 kbps.
³ To enable the low speed operation:
1. From the System Configuration, select Low Speed Operation (Main menu >
Configuration > System Configuration > Low Speed Operation).
The option value changes to Enable or Disable.
2. From the System Configuration, select Save to save the change.
3. Reset the ASMi-52.
On start up the unit will operate in low speed mode.
Low speed operation is not available in multiplexed operations.
Setting the G.704 Interface Type
The G.704 interface type refers to the remote side hardware and is applicable for
E1 only.
³ To set the G.704 interface type:
1. From the System Configuration menu, select G.704 Interface Type.
2. Select one of the following values as required:
 Autodetect
 Balanced
 Unbalanced
Configuring the Physical Ports
Configuring the SHDSL Interface
The ASMi-52 configuration software allows you to change the modem’s
transmission mode (Annex A or Annex B).
Examples given below illustrate the local device configuration procedures.
³ To change the transmission mode:
1. From the SHDSL Local Port menu, select Transmission Mode (Main menu >
Configuration > SHDSL Configuration > SHDSL Local Port > Transmission
Mode) to choose a transmission mode: Annex A or Annex B for the SHDSL
Local Port.
The display is refreshed and a new value appears.
2. Select Save to save the changes.
•
ASMi-52 units operating in the receive clock mode automatically detect the
standard compatibility value of the central units and configure themselves
accordingly.
Note
Note