Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Configuring for Operation 4-15
For available options and combinations of parameters that complies with
multiplexer conditions, see
Table 1-4 .
Local Card Mode
³ To configure local card mode:
1. From the Local menu (Main menu > Configuration > System Configuration >
Local Card Mode), select the appropriate configuration by choosing E1, DTE,
E1 + LAN, E1 + V35, or V35 + LAN (see
Figure 4-20 ).
The System Configuration menu returns.
2. From the System Configuration menu, select Save to save the changes
ASMi-52
Local/Remote Card Mode
E1
DTE
E1 + LAN
E1 + V35
V35 + LAN
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-20. Local/Remote Card Mode Menu
Remote Card Mode
The remote card mode configuration option is only available when ASMi-52 is
connected to a remote unit. When connected to a remote unit, each multiplexer
unit can be configured to work as a single unit. For example, E1+Serial DTE, E1
single, or Serial DTE single may be configured as an E1 or Serial DTE unit. A
multiplexer unit configured as a single unit does not behave as a multiplexer unit.
The following applies in remote card mode configuration.
• DTE Serial Interface as a single unit
• E1 as a single unit
• E1+Serial DTE as a multiplexer unit.
³ To configure remote card mode:
1. From the Remote menu (Main menu > Configuration > System Configuration
> Remote Card Mode), select the appropriate configuration by choosing E1,
DTE, LAN, E1 + LAN, E1 + V35, or V35 + LAN (see
Figure 4-20 ).
The System Configuration menu returns.
2. From the System Configuration menu, select Save to save the changes
Configuring Low Speed Operation
ASMi-52 can be configured to work at a speed of 64/128 kbps (2-wire) and
64/128/192/256 kbps (4-wire) when operating opposite devices with E1 DTE