Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Configuring for Operation 4-13
4.2 Configuring for Operation
Configuring ASMi-52 System Parameters
This section describes the procedures for configuring system parameters of
ASMi-52.
³ To access the Configuration menu:
• From the Main menu, select Configuration.
The Configuration menu appears (see
Figure 4-17 ).
ASMi-52
Configuration >
System configuration >
LAN configuration >
SHDSL configuration
E1 configuration
T1 configuration
DTE configuration
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-17. Configuration Menu
The ASMi-52 management software allows you to perform the following:
• Configuring master clock
• Selecting a local/remote card mode
• Configuring the local/remote card
• Enabling or disabling low speed operation
• Defining management parameters (IP parameters, system information, etc.)
• Defining control port parameters
• Resetting ASMi-52 defaults
• Performing the overall reset of the device or resetting its SHDSL interface.
³ To display the System Configuration menu:
• From the Configuration menu, select System Configuration.
The System Configuration menu appears (see
Figure 4-18 ).