Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Configuring ASMi-52 for Management 4-11
The Terminal menu appears.
4. From the Terminal menu, select Save to save the changes.
³ To enable or disable the pop-up alarms:
When the pop-up function is enabled, ASMi-52 displays the active alarms at the
bottom of the terminal screen. When the faulty condition causing the alarm is
cleared, the alarm is removed from the screen
1. From the Terminal menu, select Pop Alarm (Main menu > Configuration >
System Configuration > Control Port > Port Control >Terminal > Pop Alarm) to
choose the pop-up alarms mode: ON (pop-up alarms are enabled) or OFF
(pop-up alarms are disabled).
The display is refreshed and the new value appears.
2. Select Save to save the changes.
³ To configure the security timeout:
1. From the Terminal menu, select Security Timeout (Main menu > Configuration
> System Configuration > Control Port > Port Control > Terminal > Security
Timeout) to configure the timeout: FOREVER (timeout is disabled) or 10 MIN
(idle disconnect time – 10 min).
The display is refreshed and a new value appears.
2. Select Save to save the changes.
³ To change the dial-out parameters:
When the CONTROL port is configured to the dial out mode, you must specify the
dial-out parameters of the port. This enables ASMi-52 to build the call command
that is sent to the dial-out modem. When connecting the dial-out modem, you
must use a cross cable (see
Appendix A for the cross cable pinout).
The modem connected to the CONTROL connector must be set up as follows (for
convenience, the Hayes commands required to select the specified parameters
are listed in brackets):
• Auto-answer mode (AT S0=1 and AT S1=1)
• Call set up in response to the CONNECT string (AT X0)
• No echo (AT E0)
• Verbose mode (no codes, e.g., CONNECT string instead of 0) (AT V1).
1. From the Port Control menu (see
Figure 4-12 ), select Dial out (Main menu >
Configuration > System Configuration > Control Port > Port Control > Port
Control Mode > Dial Out).
The Dial Out menu appears (see
Figure 4-16 ).
2. From the Dial Out menu, type the following:
 1 to instruct ASMi-52 to report all alarms (ALL), only major ones (MAJOR),
or disable alarm reporting (NONE).
 2 to specify the number of dialing retries. 0, no redialing attempts are
made if the call is not established on the first attempt. 1–8, if the call is