Specifications

Chapter 4 Configuration Installation and Operation Manual
4-8 Configuring ASMi-52 for Management ASMi-52 Ver. 2.8
ASMi-52
Rate (9600 kbps)
9600 kbps
19200 kbps
38400 kbps
57600 kbps
115200 kbps
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-11. Control Port Rate Menu
Selecting the Control Port Interface
³ To select the control port interface:
1. From the Control Port menu, select Interface (Main menu > Configuration >
System Configuration > Control Port > Interface) to choose the control port
interface: DCE (direct connection to the terminal via a straight cable) or DTE
(terminal connection via modem or data link).
The display is refreshed and the new value appears.
2. Select Save to save the changes.
Selecting the CTS State
³ To select the CTS state:
1. From the Control Port menu, select CTS (Main menu > Configuration > System
Configuration > Control Port > CTS) to choose the CTS state: ON (constantly
ON) or =RTS (follows the RTS line).
The display is refreshed and a new value appears.
2. Select Save to save the changes.
Selecting the DSR State
³ To select the DSR state:
1. From the Control Port menu, select DSR (Main menu > Configuration >
System Configuration > Control Port > DSR) to choose the DSR state: ON
(constantly ON) or DTR (follows the DTR line).
The display is refreshed and a new value appears.
2. Select Save to save the changes.
Configuring the Terminal Port
The Port Control menu allows you to do the following:
• Set the port mode (terminal or dial out)