Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Configuring ASMi-52 for Management 4-5
³ To define the management access method:
1. From the Management Access menu (Main menu > Configuration > System
Configuration > Management > Management Access),
(see
Figure 4-6 ), select Telnet Allowed to enable Telnet access, or select Web
Allowed to enable management via a Web browser.
The access value toggles between Access Allowed and No Access.
2. Press <Enter> when a required value is displayed.
3. Press <Esc> to return to the Management menu (see
Figure 4-1 ).
4. From the Management menu, select Save to save your changes.
ASMi-52
Management Access
TELNET allowed (access allowed)
WEB allowed (access allowed)
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-6. Management Access Menu
Configuring Dedicated Timeslots
ASMi-52 units with an E1 or T1 port support management via a dedicated
timeslot.
A remote E1 device can be managed via DTS if the DTS mode is enabled in both
the CO unit and the CPE unit. The MNG timeslot is transferred over the SHDSL to
the E1 CPE, the CPE forwards the MNG timeslot over the E1 line to the next
device in the chain.
•
Allocate the same timeslot number for MNG in all devices in the chain. With DTS
mode enabled in all devices, the chain can be managed remotely from one NMS.
In T1 systems, the DTS manages the local unit only; it is not forwarded over
SHDSL.
³ To configure dedicated timeslots:
1. From the DTS Configuration menu (Main menu > Configuration > System
Configuration > Management > DTS Configuration), configure the dedicated
timeslot in the following order (see
Figure 4-7 ):
 Assign a DTS IP address
 Assign a DTS IP mask
 Enable the DTS mode.
2. Check the status of the DTS configuration in the Rem Agent Table (see
Figure 4-8 ).
3. From the Management menu, select Save to save the changes.
Note