Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Configuring ASMi-52 for Management 4-3
ASMi-52
Device Info
Sys description ASMi-52 SA HW Version: 0.00, SW Version:
2.01E24)
Sys contact (sss)
Sys location ()
Sys name ()
Clear sys params
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-3. Device Information Menu
Configuring the Host Parameters
ASMi-52 can be managed by a network management station, which is located on
the LAN connected to the 10/100BaseT port. In order to establish a proper
connection, it is necessary to configure the following: host IP address, subnet
mask, default gateway, its trap, read, and write communities.
³ To define the IP parameters:
1. From the Host IP menu (Main menu > Configuration > System Configuration >
Management > Host IP), type the following:
 1 to define the host IP address
 2 to define the subnet mask
 3 to set the default gateway IP address
 4 to enter the name of a community with read-only authorization
 5 to enter the name of a community with write authorization
 6 to enter the name of a community to which ASMi-52 will send traps.
2. Press <Enter>.
3. Press <Esc> to return to the Management menu (see
Figure 4-1 ).
4. From the Management menu, select Save to save your changes.
ASMi-52
Host IP
Host IP address (172.17.161.73)
Host IP mask (255.255.255.0)
Host default gateway (172.17.161.1)
Read community (public)
Write community (public)
Trap community (public)
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-4. Host IP Menu