Specifications

Chapter 3 Operation Installation and Operation Manual
3-6 Configuration and Management Alternatives ASMi-52 Ver. 2.8
Type Parameter Default Value
Line prob* Fixed rate
Units with a 4-wire line interface support
only fixed rate.
Configured wire ASMi-52 2-wire = 2w
ASMi-52 4-wire = 4w
Loop attenuation threshold 0
SNR margin threshold 0
Serial DTE Interface Rate Single:
2-wire – 192 kbps
4-wire – 384 kbps
Multiplexer:
1. E1+Serial DTE, N/A, 0 kbps
2. LAN+Serial DTE: 2-wire – 192 kbps
4-wire – 384 kbps
LLB from DTE Disable
RLB from DTE Disable
E1/E1+Ethernet/E1+Serial
DTE Interface
Framed mode Unframed
Sync CCITT
CRC-4 No
Idle Code ff
Units identical settings Yes
T1 Interface Framed mode Unframed
Line code B8ZS
Receive gain Long
Interface DSU
Transmit signal mask 0 feet
Fbit configuration Transparent
Sync mode Fast (after 1 sec)
Idle code Ff
Units identical set Yes
3.4 Configuration and Management Alternatives
After installation, ASMi-52 can be reconfigured using different ports and
applications:
• Local out-of-band management via an ASCII terminal or the Easy Config
device connected to the RS-232 port. Usually, preliminary configuration of