Specifications

Chapter 3 Operation Installation and Operation Manual
3-4 Default Settings ASMi-52 Ver. 2.8
Normal Indications
Upon turning on ASMi-52, the PWR LED in the front panel lights to indicate that
ASMi-52 is on.
Table 3-3 shows the correct status of the indicators a few
seconds after the units were synchronized.
Table 3-3. ASMi-52 Indicator Status
Indicator Status
PWR On
TST Off
ALM Off
SYNC On (green)
If the above LED indications do not appear following initial power activation, refer
to
Chapter 5 for the diagnostic test instructions.
3.3 Default Settings
ASMi-52 is managed by an ASCII terminal or a PC running a terminal emulation
program via a menu-driven embedded software.
Table 3-4 lists the default
settings of the ASMi-52 configuration parameters.
Table 3-4. Default Settings
Type Parameter Default Value
System Clock Internal
Sys contact –
Sys location –
Sys name –
Host IP address 0.0.0.0
Host IP mask 0.0.0.0
Host default gateway 0.0.0.0
Read community public
Write community public
Trap community public
SNMP allowed Access allowed
Telnet allowed Access allowed
WEB allowed Access allowed
DTS IP address 0.0.0.0