Specifications

Chapter 2 Installation and Setup Installation and Operation Manual
2-4 Connecting the Interfaces ASMi-52 Ver. 2.8
2.4 Connecting the Interfaces
Figure 2-3 illustrates a typical rear panel of ASMi-52 in a plastic enclosure with a
4-wire line interface, E1 DTE interface, user LAN interface, alarm relay port, and
the control port.
E1/T1 SHDSL
DCE
V.35
CONTROL
ALARM
LINE
B
TX
LINE
A
RX
11442255
ACTLINK
Figure 2-3. ASMi-52 Typical Rear Panel (Plastic Enclosure)
Figure
2-4 illustrates the rear panel of ASMi-52 in a metal enclosure with a 4-wire
line interface, the user LAN interface, and the control port.
SHDSL
CONTROL
LINE
B
LINE
A
1425
ACTLINK
Figure 2-4. ASMi-52 Rear Panel (Metal Enclosure)
Figure
2-5 illustrates the lower panel in the rack-mount version with the line
interface and power connected by terminal block, the user LAN interface, and the
alarm port. The control port is on the front panel.