Specifications

Installation and Operation Manual Chapter 6 Software Upgrade
ASMi-52 Ver. 2.8 Upgrading ASMi-52 Software via the Boot Menu 6-9
Loading ...
Decompressing to RAM.
Processing archive: FLASH
Extracting ASMI52.BIN
..........................................................
.................................................................... CRC OK
Running ...
*******************************************************************
* In order to start working - press the ENTER button for few times*
*******************************************************************
7. At this stage, press the <Enter> key several times to go to the log in screen.
Using the TFTP
Use the following procedure to download software release 2.8 to ASMi-52 via
TFTP.
1. Verify that the *.img file is stored on the PC with the TFTP server application.
2. Define IP parameters via the Boot Manager menu.
3. Activate the TFTP server application.
4. Download the *.img file from the PC to ASMi-52.
³ To define IP parameters via the Boot Manager menu:
1. From the Boot menu (
Figure 6-6 ), select System Configuration to start the
configuration of the ASMi-52 IP communication parameters, as needed for
TFTP transfer.
The parameters are displayed in consecutive lines. For each parameter,
you can accept the current values by simply pressing <Enter> to continue,
or type a new value:
 IP Address: used to select the IP address of ASMi-52. To change the
current value, type the desired IP address in the dotted quad format,
and then <Enter> to continue.
 IP Mask: used to select the IP subnet mask of ASMi-52. To change the
current value, type the IP subnet mask address in the dotted quad
format, and then <Enter> to continue.
 Default Gateway Address: when the TFTP server is located on a
different LAN, you must define the IP address of the default gateway
to be used by ASMi-52. Make sure to select an IP address within the
subnet of the assigned ASMi-52 IP address. To change the current
value, type the desired IP address in the dotted quad format, and
then <Enter> to end the configuration.