Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Performing Additional Tasks 4-47
³ To switch software versions:
1. From the File System menu, select the SWAP Local SW Files (Main menu > File
Utilities > File System > Swap Local SW Files) to swap files in the local
ASMi-52.
ASMi-52 displays the following message:
Request to swap SW files!!! Confirm Y/N
2. Type Y to confirm the file swap.
ASMi-52 performs the swap and sends the following string:
Program Switching
The active software becomes the backup and vice versa. At this stage,
ASMi-52 is automatically reset.
If you try to switch the software versions when only one version is available,
ASMi-52 responds with the following message:
Impossible to switch – no other program
Press any key to continue
Resetting ASMi-52
ASMi-52 supports four types of reset:
• Reset to the default setting
• SHDSL interface reset
• SHDSL repeater line reset
• Overall reset.
Resetting to Default Settings
You can reset the local or remote ASMi-52 to its default settings. Resetting to
the factory default does not affect the master clock setting. In addition, you can
reset the local ASMi-52 without affecting its management parameters (IP
address, mask and default gateway).
³ To reset ASMi-52 to the factory default:
1. From the System Configuration menu, select Factory Default. (Main menu >
Configuration > System Configuration > Factory Default).
The Factory Default menu is displayed (
Figure 4-49 ).