Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Performing Additional Tasks 4-45
³ To upload a configuration from the source device:
1. From the SW & File Transfer, select Auto Configuration (Main menu > File
Utilities > SW & File Transfer > Auto Configuration) to select an auto-
configuration type.
The Auto Configuration menu is displayed.
2. Select Command (Upload/Download Full/Part Download) and select Command
and set to Upload (see
Figure 4-48 ).
3. Select TFTP or XMODEM (as in software download).
ASMi-52
Auto Configuration
XMODEM
TFTP
Command (UPLOAD/DOWNLOAD FULL/DOWNLOAD PART)
ESC-prev. menu; !-main menu; &-exit
Figure 4-47. Software Version Screen
4. From the SW & File Transfer menu, select TFTP ( Figure 4-46 ) (Main menu >
File Utilities > SW & File Transfer > SW Download > TFTP).
5. From the TFTP menu, perform the following steps:
 Select TFTP IP Server and enter the IP address of the TFTP server
 Select TFTP File Name and enter the name of the software file (for
example, 201e24.img).
 Select TFTP Retry Timeout and specify intervals between connection
retries (in seconds).
 Select TFTP Total Timeout and specify the TFTP connection timeout (in
seconds).
 Select Save to save the TFTP configuration.
 Select Transfer Command to start downloading file to ASMi-52.
ASMi-52 automatically erases the backup partition. Once downloading is
completed, ASMi-52 saves the new release as an active partition, the
former active partition becomes the backup.
Once downloading is complete, ASMi-52 decompresses the release file,
displaying the following message:
Final process download. Reset
After the decompression, ASMi-52 saves the new release as an active
partition, the former active partition becomes backup. Then the unit
resets itself. This causes the new software to be loaded into the
modem's RAM.