Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Performing Additional Tasks 4-39
ASMi-52
Port status
Local Remote
SHDSL (Standard ANNEX_B, Wire mode 2W) ______
SHDSL Line (Status: SYNC, State: DATA mode) ______
Framer Type (SLOTTED E1) ______
EOC compatible (PROPRIETARY) ______
Actual PSD (ASYM_PSD_DISABLE) ______
Line rate (2048 kbps + 8 kbps) ______
E1 interface (IR-G704-E1/BALANCE Data rate: 2048 kbps) ______
HW status (NO HARDWARE FAILURE) ______
Test status (NONE)> ______
Alarm status (NORMAL) ______
REM connected line (1) ______
(N)
ESC-prev. menu; !-main menu; &-exit;
Figure 4-40. Port Status Menu
•
The physical port alarms are described in Chapter 5.
2. Type N to display the next page.
Accessing the Remote ASMi-52
Accessing the remote ASMi-52 is performed using a virtual connection with your
terminal physically connected to the local unit.
³ To access the remote ASMi-52
1. From the Monitoring menu (
Figure 4-38 ), select Open Virtual Connection
(Main menu > Monitoring > Open Virtual Connection).
2. The Login screen of the second ASMi-52 appears.
3. Login to the second ASMi-52.
You now have access to the second ASMi-52 menus.
•
If no key press is sensed for a period of 10 minutes, the virtual connection closes
and you are returned to the initial ASMi-52.
³ To close a virtual terminal
• From the Monitoring menu of the second ASMi-52, select Close Virtual
Connection.
The Main menu of the first
ASMi-52 is displayed.
Note
Note