Specifications

Installation and Operation Manual Chapter 4 Configuration
ASMi-52 Ver. 2.8 Configuring for Operation 4-35
•
ASMi-52 units operating in the receive clock mode automatically detect the LAN
rate of the central units and configure themselves accordingly.
³ To set the LAN rate:
1. From the Local LAN Configuration menu, select LAN Rate (Main menu >
Configuration > LAN Configuration > Local LAN Configuration > LAN Rate).
The LAN Rate menu appears (see
Figure 4-37 ).
2. From the LAN Rate menu, select the required data rate.
The Local LAN Configuration menu appears.
3. From the LAN Configuration menu, select Save to save the new value.
ASMi-52
Data Rate (2304 Kbps)
64 Kbps 12. 768 Kbps 23. 1472 Kbps
128 Kbps 13. 832 Kbps 24. 1536 Kbps
192 Kbps 14. 896 Kbps 25. 1600 Kbps
256 Kbps 15. 960 Kbps 26. 1664 Kbps
320 Kbps 16. 1024 Kbps 27. 1728 Kbps
384 Kbps 17. 1088 Kbps 28. 1792 Kbps
448 Kbps 18. 1152 Kbps 29. 1856 Kbps
512 Kbps 19. 1216 Kbps 30. 1920 Kbps
576 Kbps 20. 1280 Kbps 31. 1984 Kbps
640 Kbps 21. 1344 Kbps 32. 2048 Kbps
704 Kbps 22. 1408 Kbps 33. 2304 Kbps
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-37. LAN Rate Menu (2-Wire Version)
Setting the LAN Rate in a Multiplexer Unit
The maximum multiplexer rate is 2048 kbps (general rate). The sum of the data
rate of two interfaces should not exceed 2048 kbps.
For example:
• DTE Serial Interface + LAN – If the DTE Serial Interface works at 1024 kbps,
then LAN cannot work at a speed of more than 1024 kbps because the sum
of both interfaces cannot exceed 2048 kbps.
ASMi-52 has a multiplexer modem with two interfaces. The maximum rate for LAN
is:
• If LAN + E1, then the LAN maximum rate = 2048 kbps – used TSs (timeslots) x
64 kbps
• If LAN + DTE Serial Interface, then the LAN maximum rate = 2048 kbps –
DTE rate
Note