Specifications

Chapter 4 Configuration Installation and Operation Manual
4-32 Configuring for Operation ASMi-52 Ver. 2.8
ASMi-52
Local LAN Configuration
Operation Mode (BRIDGE)
Bridging Mode (ACCESS ONLY)
1. Bridge Table []>
2. Aging Timeout(sec)[10 - 1000000] ... (10)
3. Auto negotiation (ENABLE)
4. Max AutoNeg Capability > (100BASE_T-full duplex mode)
5. Fault indication (NO)
6. LAN rate > (N/A rate)
7. QoS mapping (Classification 802.1p) >
8. Save
>
ESC-prev. menu; !-main menu; &-exit; @-scroll
Figure 4-32. LAN Configuration Menu
•
If autonegotiation is enabled, the maximum autonegotiation capability rate is
100BaseT full-duplex mode. If autonegotiation is disabled, it is called default
type or 10BaseT.
Completing the Bridging Table
When the 10/100BaseT port operates in the bridge mode, you can assign MAC
addresses to the local or remote LAN.
³ To fill out the bridge table:
1. Select Bridging Table from the Local LAN Configuration menu (Main menu >
Configuration > LAN Configuration > Local LAN Configuration > Bridging
Table).
The Bridge Table appears (see
Figure 4-33 ).
ASMi-52
Bridge Table
MAC Address Port Type
0010b340500 LAN Static
0040e108070 DSL Static
00000000000 Static
>
ESC-prev. menu; !-main menu; &-exit; ?-help
Figure 4-33. Bridge Static Table, Normal Mode
2. From the Bridge Table, select an empty cell (the one with MAC address
0000000000 and unassigned port) by typing D to move the cursor
downwards or U to move it upwards.
Note