Specifications

ASMi-52L Installation and Operation Manual Chapter 5 Configuring a Typical Application
Configuring the ASMi-52L units 5-3

To set the device host IP address:
1. Display the host IP menu (Main menu > Configuration > System
configuration > Management > Host IP.
The host IP screen appears.
2. From the host IP menu, configure the following:
 CO ASMi-52L – 123.456.78.90
 CPE ASMi-52L – 123.456.78.91
 Host IP mask – 255.255.255.1
 Host default gateway IP address – 255.255.255.2
ASMi-52L
Host IP
Host IP address (123.456.78.90)
Host IP mask (255.255.255.1)
Host default gateway (255.255.255.2)
Read community (public)
Write community (public)
Trap community (public)
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
3. Press ESC to return to previous menu (Management screen).
4. Save the changes.
Setting the Line Interface
Set the line interface wire mode to 4-wire.

To set the wire mode:
1. Display the Configured wire screen (Main menu > Configuration > SHDSL
Configuration > SHDSL Port Configuration).
ASMi-52L
SHDSL port configuration
1. Transmission Mode (Annex B)
2. Power backoff (Enable)
3. Snext margin (Disable)
4. Current margin (Disable)
5. Asym PSD (Symmetrical)
6. Line prob (Adaptive rate)
7. Configured wire (4W)
8. Loop attenuation threshold (dB) [0-127] (0)
9. SNR margin threshold (dB) [0-15] (0)
10. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
2. Select Configured wire