Specifications

Chapter 4 Configuration ASMi-52L Installation and Operation Manual
4-22 Displaying the ASMi-52L Status
 10BaseT full duplex
 100BaseT half duplex
 100BaseT full duplex.
6. From the LAN Configuration menu, select Save.
Configuring Fault Indication
If ASMi-52L fault indication is enabled and a fault condition or loss of signal is
detected on the line, the Ethernet link is disconnected by ASMi-52L. If fault
indication is not selected, fault conditions are not passed through to the LAN side.

To set the fault indication:
1. From the LAN Configuration menu, select fault indication.
Toggle between Yes and No.
2. Select Save to save your changes
4.4 Displaying the ASMi-52L Status
The ASMi-52L software allows you to display the modem system and physical port
information.
The status information is available via the Monitoring menu.

To access the Monitoring menu:
• From the Main menu, select Monitoring.
The Monitoring menu appears (see Figure 4-27).
ASMi-52L
Monitoring
1. Total Alarms []>
2. System monitoring >
3. Physical ports status >
4. Physical ports statistics
5. Open Virtual Connection
>
ESC-prev.menu; !-main menu; &-exit;
Figure 4-27. Monitoring Menu
Displaying the System Status

To display the system information:
• Follow the path: Monitoring >System monitoring > System status)
The System Status screen appears (see Figure 4-28).