Specifications

Chapter 4 Configuration ASMi-52L Installation and Operation Manual
4-18 Configuring the Physical Ports
Configuring the LAN Port
An ASMi-52L unit fitted with a 10/100BaseT port can be used as a user or
management port. The LAN port operates in a self-learning bridge mode, with or
without autonegotiation.
Configuring LAN Port Operation Mode
In the transparent mode the LAN port operates with disabled filter, passing all
frames transparently. When operating as a self-learning bridge, the LAN port filters
the packets received from the local LAN and transfers through the link only frames
destined to another LAN.

To configure the LAN operation mode:
1. From the Configuration menu, select LAN Configuration.
The LAN Configuration menu appears (see Figure 4-22).
2. From the LAN Configuration menu, select Operation Mode.
The Operation Mode menu appears.
3. From the Operation Mode menu, select Transparent to enable transparent
mode, or select Bridge to enable bridge mode.
For modems with the 10/100BaseT user LAN interface, the default is Bridge.
The LAN Configuration menu appears.
4. From the LAN Configuration menu, select Save to save your changes.
ASMi-52L
LAN Configuration
Operation Mode (Bridge)
Bridging Mode (Switching)
1. Bridge Table []>
2. Aging Timeout(sec)[10 - 1000000] (10)
3. Auto negotiation (Enable)
4. Max AutoNeg Capability (100BASE_T-full duplex mode)
5. Fault indication (Yes)
6. LAN rate (2304)
7. QoS Mapping (Classification 802.1p) <
8. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-22. LAN Configuration Menu, (one Ethernet port)
The 4-Ethernet port ASMi-52L has a different LAN configuration menu. Items 3 and 4
are in the Ethernet Configuration sub-menu.
Note
Note