Specifications

Chapter 4 Configuration ASMi-52L Installation and Operation Manual
4-16 Configuring the Physical Ports
The SHDSL repeaters are configured via the SHDSL Repeater Configuration menu.

To access the SHDSL Repeater Configuration menu:
• From the SHDSL Configuration menu (Configuration > Physical Ports
Configuration > SHDSL Configuration menu), select SHDSL repeater
configuration.
The SHDSL Repeater Configuration menu is displayed (see Figure 4-18).
ASMi-52L
SHDSL repeater configuration
1. Power backoff (Disable)
2. Loop Attenuation threshold (dB)[0 - 127] (0)
3. SNR margin threshold (dB)[0 – 15] (0)
4. Repeater number > (1)
5. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-18. SHDSL Repeater Configuration Menu
Configuring the Serial DTE Interface
If the ASMi-52L modem is equipped with a serial data interface, the configuration
software allows you to enable/disable the LLB/RLB activation from the DTE (except
for X.21) and select the modem’s data rate.
Configuring LLB/RLB Activation from the DTE

To enable/disable the LLB/RLB activation from the DTE:
1. From the Physical Ports Configuration menu, select DTE Configuration.
The DTE Configuration menu appears (see Figure 4-19).
2. Select DTE local port configuration to configure the local DTE port or select
DTE remote port configuration for the remote port configuration.
DTE Local/Remote Port Configuration menu appears (see Figure 4-20).
3. From the DTE Local/Remote Port Configuration menu, select LLB from DTE to
enable the LLB activation from the DTE or select RLB from DTE to enable the
RLB activation from the DTE.
The display is refreshed and a new value appears.
4. Select Save to save the changes.
ASMi-52L
DTE configuration >
Port number: (1)
1. DTE local port configuration
2. DTE remote port configuration
>
ESC-prev.menu; !-main menu; &-exit; @-scroll