Specifications

ASMi-52L Installation and Operation Manual Chapter 4 Configuration
Configuring ASMi-52L System Parameters 4-11
 2 to specify the number of dialing retries. 0, no redialing attempts are made
if the call is not established on the first attempt. 1–8, if the call is not
established on the first attempt, ASMi-52L makes the specified number of
redials.
This parameter applies to both primary and alternate numbers:
 If the call is not established after dialing the primary directory number the
specified number of times, ASMi-52L attempts to establish the call by
dialing the alternate directory number (provided the use of an alternate
number is enabled).
 If the call cannot be established within the specified number of redialing
attempts on neither of the two directory numbers, ASMi-52L stops the
call attempts. When a new alarm report must be sent, the call attempts
are started again. The user is notified that the call attempts failed by a
message recorded in the alarm log file (separate messages are provided
for each directory number).
 3 to specify the time (in sec) ASMi-52L waits for an answer after each dialing
attempt. If the called station does not answer within the specified time,
ASMi-52L disconnects. If additional call attempts are allowed,
ASMi-52L redials immediately after disconnecting. The available selections
are 30, 45, or 60 seconds.
 4 to select the dialing mode. TONE, the dial-out modem is instructed to use
DTMF dialing. PULSE, the dial-out modem is instructed to use pulse dialing.
 5 to control the use of an alternate number. The alternate number is dialed
after the specified number of call attempts on the primary number failed.
ENABLE, the use of an alternate number is enabled. DISABLE, ASMi-52L
stops the call attempts after the specified number of call attempts on the
primary number failed.
 6 to specify a primary number to dial.
 7 specify an alternate number to dial.
3. Select Save to save the changes.
ASMi-52L
Dial out
1. Call Out Mode (None)
2. Number of Retries [0-8] (1)
3. Wait for connect (30 sec)
4. Dial mode (Tone)
5. Alternate number mode (Disable)
6. Primary number ()
7. Alternate number ()
8. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-15. Control Port Dial Out Menu