Specifications

Chapter 4 Configuration ASMi-52L Installation and Operation Manual
4-10 Configuring ASMi-52L System Parameters
ASMi-52L
Terminal
1. Change access >
2. POP ALARM (OFF)
3. Security timeout (10 min)
4. Save
>
ESC-prev.menu; !-main menu; &-exit; @-scroll
Figure 4-14. Terminal Menu

To enable or disable the pop-up alarms:
When the pop-up function is enabled, ASMi-52L displays the active alarms at the
bottom of the terminal screen. When the fault condition that caused the alarm is
cleared, the alarm is removed from the screen
1. From the Terminal menu, select Pop Alarm to choose the pop-up alarms mode:
ON (pop-up alarms are enabled) or OFF (pop-up alarms are disabled).
The display is refreshed and the new value appears.
2. Select Save to save the changes.

To configure the security timeout:
1. From the Terminal menu, select Security Timeout to configure the timeout:
FOREVER (timeout is disabled) or 10 MIN (idle disconnect time – 10 min).
The display is refreshed and a new value appears.
2. Select Save to save the changes.

To change the dial-out parameters:
When the CONTROL port is configured to the dial out mode, you must specify the
dial-out parameters of the port. This enables ASMi-52L to build the call command
that is sent to the dial-out modem. When connecting the dial-out modem, you must
use a cross cable (see Appendix A for the cross cable pinout).
The modem connected to the CONTROL connector must be set up as follows (for
convenience, the Hayes commands required to select the specified parameters are
listed in brackets):
• Auto-answer mode (AT S0=1 and AT S1=1)
• Call set up in response to the CONNECT string (AT X0)
• No echo (AT E0)
• Verbose mode (no codes, e.g., CONNECT string instead of 0) (AT V1).
1. From the Port Control menu (see Figure 4-12), select Dial out.
The Dial Out menu appears (see Figure 4-15).
2. From the Dial Out menu, type the following:
 1 to instruct ASMi-52L to report all alarms (ALL), only major ones (MAJOR),
or disable alarm reporting (NONE).