Specifications

ASMi-52L Installation and Operation Manual Chapter 3 Operation
Configuration Alternatives 3-5
3.4 Configuration Alternatives
If required, ASMi-52L can be reconfigured. The ASMi-52L configuration and
monitoring operations are performed using any of the following tools:
• ASCII Terminal Connected to Supervisory Port (Command Line Interface or
menu driven)
• ConfiguRAD, a Web-based management system, using a Web browser running
on a PC connected to the network
• RADview, an SNMP based management system with a Graphical User
Interface. See the RADview-MDM User's Manual, for details.
Detailed configuration procedures are given in Chapter 4.
The following functions are supported by the ASMi-52L management software:
• Viewing system information
• Modifying configuration and mode of operation, including setting system
default values
• Monitoring ASMi-52L performance
• Initiating diagnostic tests
• Upgrading software.
Configuring via a Terminal

To start a terminal control session:
1. Make sure all ASMi-52L cables and connectors are properly connected.
2. Connect ASMi-52L to a PC equipped with an ASCII terminal emulation
application (for example, Windows Hyper Terminal or Procomm).
3. Turn on the control terminal PC and set its port parameters to 9.6 kbps,
8 bits/character, 1 stop bit, no parity. Set the terminal emulator to ANSI VT100
emulation (for optimal view of system menus).
4. When the initialization and self-test are over, a menu appears displaying
initialization and self-test results. If problems are encountered, refer to
Chapter 4 for instructions.
Login

To enter the user name and password:
1. Type in your user name and press <Tab>.
The default user name is su, although you may leave the field blank, and the default
password is 1234.
2. Type in your password at the > prompt (up to eight characters).
ASMi-52L responds to your entry with asterisks.
3. Press <Enter>.
Note