Specifications

Chapter 1 Introduction ASMi-52L Installation and Operation Manual
1-4 Overview
Table 1-2. ASMi-52L Data Rates
Clock Mode Line Interface
Local ASMi-52L Remote ASMi-52L 2-wire
[kbps]
4-wire
[kbps]
Internal Receive 64, 128, 192, 256, 384, 512,
576, 768, 1024, 1152, 1536,
2048, 2304
128, 256, 384, 512, 768, 1024,
1152, 1536, 2048, 2304, 3072,
4096, 4608
External Receive
N × 64 kbps
(N = 1…36)
N × 128 kbps
(N = 1…36)
Timing
ASMi-52L supports three clock modes:
• Internal, derived from its internal oscillator (CO mode)
• External, supplied by the attached DTE
• Receive, recovered from the received line signal (CPE mode).
Management
ASMi-52L supports the following management options:
• Telnet via dedicated 10/100BaseT port
• SNMP network management (RADview) via dedicated 10/100BaseT port in
Ethernet options only
• PC, running a Web browsing application (ConfiguRAD).
EOC
ASMi-52L provides an inband management channel (EOC) for end-to-end system
management and supervision. This management channel uses SHDSL overhead
bits and operates without interfering with data transmission.
ConfiguRAD
ConfiguRAD is user-friendly Web-based terminal management system serving for
remote device configuration and maintenance. It is embedded in ASMi-52L and
provided at no extra cost. ConfiguRAD can be run from any standard Web
browser.
Dial-In
The V.24 terminal port supports dial-up modem connection for remote
management of ASMi-52L over telephone lines.
Dial-Out
The V.24 terminal port supports alarm dial-out.
Diagnostics
ASMi-52L supports activation of the following:
• Local loopback
• Remote loopback
• Remote loopback at SHDSL repeater (activated from the local unit).