Specifications

Appendix B Parameter List Installation and Operation Manual
B-8 Configure Transmission Parameters ASMi-52CQ Ver. 2.12
Parameter Type Use Value Indication
RECEIVE GAIN Write Sensitivity of the
receive equalizer
Long -36 dB
Short 15 dB
INTERFACE Write DSU
CSU
DSU interface
CSU interface
Transmit signal
mask (DSU mode)
Write Length of a cable in
feet between the T1
port connector and the
network access point
0 feet
133 feet
266 feet
399 feet
0 to 133 feet
133 to 266 feet
266 to 399 feet
399 to 533 feet
Transmit signal
mask (CSU mode)
Write Relative T1 output
transmit level
7.5 dB
15 dB
22.5 dB
Attenuation of 7.5 dB relative
to the nominal transmit level
Attenuation of 15 dB relative
to the nominal transmit level
Attenuation of 22.5 dB relative
to the nominal transmit level
Fbit configuration Write Fbit transmission mode Transparent
Internally Source
F bits are sampled at TSER
F bits are sourced internally
IDLE CODE Write Selects the code
transmitted to fill idle
(unused) timeslot in the
E1 frames
Hex value from
00 to FF
BALANCE Read Indicates whether the
interface is balanced or
unbalanced
Balanced
Unbalanced
TS Write Assigns each timeslot to
carry data
DATA
NOT_CONNECT
Timeslots are assigned to carry
data
Unit Identical Set Write Copies Sync Mode, Time
Slot Assignment and
Idle Code definitions to
remote modem
YES Copies parameters to the
remote modem