Specifications

Installation and Operation Manual Chapter 5 Troubleshooting and Diagnostics
ASMi-52CQ Ver. 2.12 Testing ASMi-52CQ 5-9
5.5 Testing ASMi-52CQ
The user-controlled test functions of ASMi-52CQ consist of the loopback tests,
BER test and LEDs tests. The purpose of these tests is to determine the source of
a break in the data flow.
The Modem Diagnostic screen enables you to configure loopback connections,
and initiate LEDs test.
Initiating Loopback and LED Tests
³ To initiate loopback or LED tests:
1. From the Main menu, select Modem Diagnostics.
2. Select the ASMi-52CQ slot.
The Modem Diagnostics menu appears.
MODEM DIAGNOSTICS
MODEM NAME: ASMi-52CQ
DEFINE MODEM PORT NUMBER : 1
MODEM STATUS : MASTER PERMANENT
SELECT MODEM : MODEM 1 LOCAL
LOOP & BERT : CANCEL LOOP TIMEOUT(MIN) : N/A
REMOTE DIG ENABLE : N/A LOOP TIMEOUT(0-4095 MIN): 5
BERT RESULTS : 0.0 E- 00
LED TEST : OFF
LOCAL LOOP BACK : DISABLE
REMOTE LOOP BACK : DISABLE
REMOTE DIG : N/A
ENABLE TEST FROM REM MODEM : N/A
BERT ERR INJECTION : NO ERR
BERT PATTERN : MARK
BERT CLEAR COUNTERS : NO
Figure 5-4. Modem Diagnostic Menu
Rows in bold in the figures indicate parameters applicable to ASMi-52CQ and
standalone modems. Additional, non-bolded parameters listed on a screen apply
to other modems installed in the LRS-24 hub.
The Modem Diagnostics screen fields and the options for each field are explained
in
Table 5-5.