Specifications

Chapter 4 Configuration Installation and Operation Manual
4-4 Configuring the Modem ASMi-52CQ Ver. 2.12
• If the opposite modem is E1, then the Framed Mode value can be G732N,
G732S Transparent, or Unframed.
• If the opposite modem is Serial DTE or LAN, then the Framed Mode value can
be G732N, or Unframed
• If Frame Mode is Unframed, then all the rest of the parameters are disabled.
 Sync mode
 CRC-4
 Idle Code
 Timeslot Assign
 Unit Identical Set
 First timeslot for remote E1 – define the first timeslot for the remote E1
unit.
Configuring the T1 Interface
1. In the Modem Setup menu, move the cursor to NEXT PARMETERS (T1) field by
pressing <Tab> and select YES by pressing <F> or <B>.
The Modem Setup menu: T1 Parameters screen appears.
2. Configure the following T1 parameters:
 Framing mode
 Line coding
 Idle Code
 Timeslot Assign
 Unit Identical Set
 Receive gain
 Interface
 Transmit signal mask
 Fbit configuration.
Configuring the Line Parameters
³ To configure the Line parameters:
1. If you have configured E1/T1 parameters, press <ESC> to return to the Main
menu, and then repeat the steps above to access the Modem Setup menu.
2. In the Modem Setup menu, move the cursor to NEXT PARMETERS (LINE) field
by pressing <Tab> and select YES by pressing <F> or <B>.
The Modem Setup menu: Line Parameters screen appears.
3. Configure the following line parameters:
 Power backoff
 Snext margin, if line probing is set to adaptive
Note