Specifications

ASMi-52CQ Ver. 2.12 Introduction 4-1
Chapter 4
Configuration
This chapter describes how to configure the ASMi-52CQ modem installed in the
LRS-24 hub using an ASCII terminal. It briefly describes basic modem
configuration. Refer to
Appendix C for a more detailed description of modem
setup commands. The following items are described in this section:
• Selecting menu options
• Configuring the modem.
4.1 Introduction
The terminal is used to configure, monitor and perform diagnostic tests of the
LRS-24 chassis and modems installed in it. Specific screens are used for each of
these management operations.
The ASCII terminal operations for the LRS-24 hub are described in the
LRS-24 installation and operation manual. That manual provides instructions for:
• Accessing various terminal screens
• Configuring control parameters
• LRS-24 management operations.
The LRS-24 management screens available through the ASCII terminal handle the
hub functions for:
• IP management network
• LRS-24 chassis status.
The LRS-24 hub screens also provide information on modems installed in the
chassis and their alarm status (see
Table 4-1).
For SNMP RADview operation, refer to the RADview user’s manual.
Note