Specifications

Installation and Operation Manual Chapter 3 Operation
ASMi-52CQ Ver. 2.12 Initiating an ASCII Terminal Session 3-3
Normal Operation
After power-up the LEDs should assume the states as shown in Table 3-2 .
Table 3-2. Normal State of LEDs
ID Color State
POWER Green ON
DATA Yellow Blinking
TST Red OFF
ALM Red OFF
SYNC Green/Red Green
3.3 Initiating an ASCII Terminal Session
³ To enable an ASCII terminal session:
1. Connect the terminal to the CM-2 RS-232 front connector of the LRS-24
chassis.
2. Power up the hub.
The LRS-24 Main menu appears (see
Figure 3-2 ). You are prompted for a
password.
3. If a password has been assigned, type the password and press <Enter>.
If no password has been assigned (default), press <Enter>.
The CM2> prompt appears.
³ To select an option in the Main menu:
1. Type the number corresponding to the option and press <Enter>.
The following message appears:
Please enter the slot number (1-12)
2. Type the slot number of the ASMi-52CQ card and press <Enter>.
The screen for the selected command option appears.