System information

System Level – Statistics Menu 4-1
Chapter 4
Performance Monitoring
This chapter describes the RADview options for viewing and clearing statistics
information for ASMi-52. These options also include setting the Polling Interval.
4.1 System Level – Statistics Menu
The Statistics menu allows you to set the Polling Interval at the system level.
Figure 4-1. System Level Statistics Menu
Setting the Polling Interval
The Polling Interval command enables you to set the Polling Interval at the system
level.

To set the Polling Interval at the system level:
1. At the system level, select Statistics > Polling Interval…
2. Enter the desired parameter and click <Set>.
Figure 4-2. Polling Interval Dialog Box
Table 4-1. Polling Interval Parameters
Parameter Possible Values/Remarks
Polling Interval
(sec)
The interval at which the Agent will be polled (in seconds)
5, 10, 15…60
Default: 10
Note: The value you enter will be the interval used for both the current and running Agent
statistics on all ports
[Set] Click <Set> to set the Polling Interval
[Cancel] Click <Cancel> to close the Polling Interval dialog box