System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-34 Repeater Level – Configuration Menu
Configuring the Repeater Parameters
The Parameters command enables you to configure the repeater parameters.

To configure the repeater parameters:
1. At the repeater level, select Configuration > Parameters…
2. Configure the desired parameters and click <Set>.
Figure 3-33. Repeater Parameters Dialog Box{need new graphic}
Table 3-25. Repeater Parameters
Parameter Possible Values / Remarks
Repeater
1…8
Wiring
2 Wire, 4 Wire
Loop Attenuation
Threshold (dB)
Unchecked (Loop Attenuation Threshold disabled),
Checked (Loop Attenuation Threshold enabled)
1…127
Note: This field is read-write when the SHDSL Mode is STU-C and read-only when the
SHDSL Mode is STU-R
SNR Margin
Threshold (dB)
Unchecked (SNR Margin Threshold disabled),
Checked (SNR Margin Threshold enabled)
1…15
Note: This field is read-write when the SHDSL Mode is STU-C and read-only when the
SHDSL Mode is STU-R
[Set] Click <Set> to set the repeater configuration parameters
[Cancel] Click <Close> to close the Repeater Parameters dialog box
[Refresh] Click <Refresh> to update the Repeater Parameters dialog box