System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
Repeater Level – Configuration Menu 3-33
Table 3-24. Port Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Port
CONTROL
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Rate (bps) The rate of the CONTROL port (in bits per second)
9600, 19200, 38400, 57600, 115200
Data Bits
7, 8
Parity
None, Odd, Even
CTS
ON, RTS
Interface
DCE, DTE
DCD Delay (msec) 0, 10, 50, 100, 200, 300 (in milliseconds)
Note: This field is disabled when the Interface value is DCE
DSR
ON, DTE
Note: This field is disabled when the Interface value is DTE
Mode
Terminal, Dial Out, NMS SLIP, SMS PPP
Call Out Mode
None, All, Major
Dial Retries
0…8
Wait for Connect
(sec)
30, 45, 60
Dial Mode
Tone, Pulse
Primary Dial No.
Note: The maximum number of characters for this field is 20
Alternate No. Use
No, Yes
Alternate Dial No.
Note: The maximum number of characters for this field is 20
[Set] Click <Set> to set the port configuration parameters
[Cancel] Click <Cancel> to close the Port Parameters dialog box
[Refresh] Click <Refresh> to update the Port Parameters dialog box
3.10 Repeater Level – Configuration Menu
The Configuration menu enables you to configure at the repeater level.
Figure 3-32. Repeater Level Configuration Menu