System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
CONTROL Port Level – Configuration Menu 3-31
Figure 3-29. DTE (V.35, RS-530) Port Parameters Dialog Box
Table 3-23. DTE (V.35, RS-530) Port Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Port CONTROL, ETH, SHDSL Link, E1, T1, DTE (V.35, RS-530)
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Enable LLB from
DTE
Enables the local loop back option for the data terminal equipment
Unchecked (disabled)
Checked (enabled)
Enable RLB from
DTE
Enables the remote loop back option for the data terminal equipment
Unchecked (disabled)
Checked (enabled)
[Set] Click <Set> to set the port configuration parameters
[Cancel] Click <Cancel> to cancel the setting of the port configuration parameters
[Refresh] Click <Refresh> to update the data in the DTE (V.35, RS-530) Port Parameters dialog
box
3.9 CONTROL Port Level – Configuration Menu
The Configuration menu enables you to configure at the CONTROL port level.
Figure 3-30. CONTROL Port Level Configuration Menu