System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual

3-30 DTE (V.35, RS-530) Port Level – Configuration Menu

Parameter Possible Values / Remarks

[Set] Click <Set> to set the port configuration parameters

Note: If you changed the Line Type value to “Unframed” or the Same Far End Settings

value to “Yes”, then a confirmation message appears indicating that the time slot

assignment will be deleted

Note: If you changed one of the DTS Configuration values, a confirmation message

appears indicating that these changes may disconnect the Agent

[Cancel] Click <Cancel> to cancel the setting of the port configuration parameters

[Refresh] Click <Refresh> to update the data in the Port Parameters dialog box

3.8 DTE (V.35, RS-530) Port Level – Configuration Menu

The Configuration menu enables you to configure at the DTE (V.35, RS-530) port

level.

Figure 3-28. DTE (V.35, RS-530) Level Configuration Menu

Configuring the DTE (V.35, RS-530) Port Parameters

The Parameters command enables you to configure the parameters for the DTE

(V.35, RS-530) port.

This command is not available for the DTE (X.21) port.

The Enable LLB from DTE and Enable RLB from DTE checkboxes that appear below

are disabled for the FE modem when it is unmanaged or unknown.



To configure the port parameters:

1. At the DTE (V.35, RS-530) port level, select Configuration > Parameters…

2. Configure the desired parameters and click <Set>.

Note