System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-28 E1 and T1 Port Levels – Configuration Menu
Table 3-21. Port Parameters
Parameter Possible Values / Remarks
Location Near-End, Far-End
SHDSL Mode STU-C, STU-R
Port CONTROL, ETH, SHDSL Link, E1, T1, DTE (V.35, X.21, RS-530)
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Line Type The line type of the E1 port
Unframed, E1 (G732N), E1-CRC (G732N-CRC), E1-MF (G732S)
Note: This field is read-only for the FE modem
Identical settings Whether the configuration settings are the same for the FE modem
No, Yes
Note: This field is read-only for the FE modem
TS0 Mode The time slot mode of the port
Looped, Transparent
Note: This field is read-only for the FE modem
Sync Mode The synchronization mode of the E1 port
TR-62411, CCITT, FAST
Note: This field is read-only for the FE modem
Idle Code (hex) The idle code of the E1 port
0…FF
Note: This field is read-only for the FE modem
Dedicated TS
Configuration
Inband Mng The inband management type of the DTS configuration
None, Dedicated TS/FR
Note: This field is unavailable for the FE modem
Tx to Remote Disable, Enable
Note: This field is available for the FE modem when it is connected to an E1
[Set] Click <Set> to set the port configuration parameters
Note: If you change the Line Type value to Unframed or the Same Far End Settings value
to Yes (when the SHDSL Mode is of type STU-R), a confirmation message will appear
indicating that the time slot assignment will be deleted
Note: If you change one of the DTS Configuration values, a confirmation message will
appear indicating that the Agent may be disconnected
[Cancel] Click <Cancel> to close the Port Parameters dialog box
[Refresh] Click <Refresh> to update the Port Parameters dialog box