System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-26 E1 and T1 Port Levels – Configuration Menu
Table 3-20. Ethernet Port Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Port
CONTROL, ETH, SHDSL Link, E1, T1, DTE (V.35, X.21, RS-530)
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
MAC Address MAC address of the ETH port
Auto Negotiation
(NE modem only)
Enable, Disable
Max Capability
Advertised
(NE modem only)
10 Base-T Half Duplex, 10 Base-T Full Duplex, 100 Base-TX Half Duplex,
100 Base-TX Full Duplex
Note: This field is available only if the auto-negotiation is enabled
Default Type
(NE modem only)
10 Base-T Half Duplex, 10 Base-T Full Duplex, 100 Base-TX Half Duplex,
100 Base-TX Full Duplex
Note: This field is available only if the auto-negotiation is disabled
[Set] Click <Set> to set the port configuration parameters
[Cancel] Click <Cancel> to close the Parameters dialog box
[Refresh] Click <Refresh> to update the Parameters dialog box
3.7 E1 and T1 Port Levels – Configuration Menu
The Configuration menu enables you to configure at the E1 and T1 port levels.
Figure 3-26. E1 (or T1) Port Level Configuration Menu
Configuring the Parameters for the E1 Port
The Parameters command enables you to configure the E1 port parameters.

To configure the parameters for the E1 port:
1. At the E1 port level, select Configuration > Parameters…
2. Configure the desired parameters and click <Set>.