System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
SHDSL Link Port Level – Configuration Menu 3-23
Parameter Possible Values / Remarks
Line Probe Enable
Enable, Disable
Note: This field is enabled for a 2-wire NE modem with a SHDSL Mode of type STU-C
Note: This field is read-only for the FE modem
Current SNR
Margin (dB)
Unchecked (Current SNR Margin disabled),
Checked (Current SNR Margin enabled)
-10…+10
Note: This field is read-only for the NE modem, or when the Line Probe is disabled
Worst Case SNR
Margin (dB)
Unchecked (Worst Case SNR Margin disabled),
Checked (Worst Case SNR Margin enabled)
-10…+10
Note: This field is read-only for the NE modem, or when the Line Probe is disabled
Power Spectral
Density (PSD) Mask
Symmetric, Asymmetric
Note: This field is read-only for the FE modem, or for a modem with an SHDSL Mode of
STU-C and when the Line Probe is disabled
Loop Attenuation
Threshold (dB)
Unchecked (Loop Attenuation Threshold disabled),
Checked (Loop Attenuation Threshold enabled)
1…127
Note: This field is read-write only when the SHDSL Mode is STU-C
SNR Margin
Threshold (dB)
Unchecked (SNR Margin Threshold disabled),
Checked (SNR Margin Threshold enabled)
1…15
Note: This field is read-write only when the SHDSL Mode is STU-C
[Set] Click <Set> to set the port configuration parameters
[Cancel] Click <Cancel> to close the Port Parameters dialog box
[Refresh] Click <Refresh> to update the Port Parameters dialog box
Viewing the SHDSL Link Port Status Configuration
The Status command enables you to view the SHDSL Link port status configuration.
This command does not display status values for the FE modem.

To view the SHDSL Link port status configuration:
• At the SHDSL Link port level, select Configuration > Status…
Note