System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
SHDSL Link Port Level – Configuration Menu 3-21
Parameter Possible Values / Remarks
Run Time
(sec)
Time elapsed since BERT started to run (sec)
Errored
Seconds
Number of errored seconds detected since BERT started to run
Sync Loss (sec) Number of times Sync Loss was detected since BERT started to run
Error Bits Number of Error Bits detected since BERT started to run
BERT Result Number of Error Bits divided by the total number of bits
Inject Error
Command
Note: This group only exists for the NE modem
[Single] Click <Single> to inject errors to the FE modem
[Polling] Click <Polling> to open the Polling Interval dialog box.
Select the polling interval in seconds and click <Set> to accept the change
[Close] Click <Close> to close the BERT Counters dialog box
[Refresh] Click <Refresh> to refresh the BERT Counters dialog box
3.5 SHDSL Link Port Level – Configuration Menu
The Configuration menu enables you to configure at the SHDSL Link port level.
Figure 3-21. SHSDL Link Port Level Configuration Menu
Configuring the SHDSL Link Port Parameters
The Parameters command enables you to configure the SHDSL Link port
parameters.

To configure the SHDSL Link port parameters:
1. At the SHDSL Link port level, select Configuration > Parameters…
2. Configure the desired parameters and click <Set>.