System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
Modem Level – Configuration Menu 3-17
Configuring QoS Mapping
Figure 3-17. QoS Mapping Dialog Box
Table 3-15. QoS Mapping Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Classification
802.1p
Mapping
User Priority
0…7
Traffic Class
0…3
[Set] Click <Set> to update the Traffic Class field
[Traffic Class] When clicked this opens a sub-menu with the following values:
0 (= High)
1
2
3 (=Low)
Selecting one of these sub-entries updates the Traffic Class value of the selected cell.
Note: This field is only enabled when a cell is selected.
[Cancel] Click <Cancel> to close the QoS Mapping dialog box
[Refresh] Click <Refresh> to update the QoS Mapping dialog box