System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-16 Modem Level – Configuration Menu
Table 3-13. Bridging Table Parameters
Parameter Possible Values / Remarks
Location Near-End, Far-End
SHDSL Mode STU-C, STU-R
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Mac Address MAC address of the bridging table
Port LAN, SHDSL, E1 or T1
Type Learned, Static
[Add…] Click <Add> to add a static entry to the Bridging Table
Refer to Adding a Static Entry to the Bridging Table
[Remove] Click <Remove> to delete a selected static entry from the Bridging Table
[Remove All] Click <Remove All> to remove all selected static entries
[Close] Click <Close> to close the Bridging Table dialog box
[Refresh] Click <Refresh> to update the data in the Bridging Table dialog box
Adding a Static Entry to the Bridging Table
The Add button in the Bridging Table dialog box enables you to add a static entry
to the table.

To add a static entry to the Bridging Table:
1. At the modem level, select Configuration > Bridging Table…
2. Click <Add…> in the Bridging Table dialog box.
Figure 3-16. Bridging Table: Add Static Entry Dialog Box
Table 3-14. Bridging Table: Add Static Entry Parameters
Parameter Possible Values / Remarks
Mac Address
(Hex)
MAC address of the static entry
Port LAN (Near-End), SHDSL (Near-End), E1/T1 (Near-End)
Default: LAN (Near-End)
Note: This field displays a value only when a port physically exists in the modem
[Apply] Click <Apply> to add the new entry to the Bridging Table
[Close] Click <Close> to close the Bridging Table: Add Static Entry dialog box