System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-14 Modem Level – Configuration Menu
Figure 3-14. LAN Configuration Dialog Box
Table 3-12. LAN Configuration Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Operation Mode
Bridge
Note: This field is read-only
Aging Time (sec)
10…1000000
Default: 10
Note: This field is disabled when the Operation Mode is Transparent
Bridging Mode
Access & Switch, Access Only
Default: Access & Switch
Note: This field is read-only
[Set] Click <Set> to update the Aging Timeout (sec) and Operation Mode fields
[Cancel] Click <Cancel> to close the LAN Configuration dialog box
[Refresh] Click <Refresh> to update the data in the LAN Configuration dialog box
Configuring the Bridging Table
The Bridging Table command enables you to configure the Bridging Table.
This command is not available for an unmanaged FE modem.

To configure the Bridging Table:
1. At the modem level, select Configuration > Bridging Table…
2. Configure the desired parameters and click <Set>.
Note