System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
Modem Level – Configuration Menu 3-13
Figure 3-13. Group Connection Dialog Box
Table 3-11. Group Connection Parameters
Parameter Possible Values / Remarks
Connect
All Click the radio button to the left of <All> to transfer all time slots to the G.SHDSL line
Note: The No. of TSs and Start TS fields will be disabled
Sequence
Click the radio button to the left of <Sequence> to specify a specific time slot sequence
Note: The No. of TSs and Start TS fields will be enabled
Start TS The first time slot in the group
1…31 (E1)
1…24 (T1)
Default: 1
Note: If the Line Type value in the Port Parameters Dialog Box is E1-MF (G732S) or
E1-CRC-MF (G732SCRC), you cannot select the value 16 for this field
Refer to Configuring the Parameters for the E1 Port
No. of TSs The total number of time slots in the group
1…31 (E1)
1…24 (T1)
Default: 1
[OK] Click <OK> to set the time slot group parameters
[Cancel] Click <Cancel> to close the Group Connection dialog box
Configuring the LAN
The LAN Configuration command enables you to configure the LAN.
This command is not available for an unmanaged FE modem.

To configure the LAN:
1. At the modem level, select Configuration > LAN Configuration…
2. Configure the desired parameters and click <Set>.
Note