System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-12 Modem Level – Configuration Menu
Parameter Possible Values / Remarks
[OK] Click <OK> to set the time slot configuration parameters as displayed in the Near End
Modem and Far End Modem tables
Note: This button is disabled if only one port is supported
Note: If you remove all table values of type Mng TS, a warning message will appear
indicating that the Agent may be disconnected
[Cancel] Click <Cancel> to close the E1 (or T1) TSA dialog box
[Group…] Click <Group…> to define time slot groups
Note: This button is only enabled when no table cell is selected
Refer to
Defining Time Slot Groups
[Data] Click <Data> to change the TS type of the selected time slot to Data
Note: This button is only enabled when a lower gray table cell is selected
[Mng] Click <Mng> to change the TS type of the selected time slot to Mng
Note: This button is only enabled when the Inband Mng value in the Port Parameters
Dialog Box is not None, and when a lower gray table cell is selected
Refer to
Configuring the Parameters for the E1 Port
[Disconnect] Click <Disconnect> to remove a time slot connection
Note: This button is only enabled when a yellow or green table cell is selected
[Reset All] Click <Reset All> to remove all time slot connections
Note: A warning message will appear
[Refresh] Click <Refresh> to update the data in the E1 (or T1) TSA dialog box
Defining Time Slot Groups
The Group button enables you to define time slot groups.
This command is not available for the FE modem.

To define time slot groups:
1. At the modem level, select Configuration > Bandwidth Allocation…
2. Click TSA... in the E1/T1 field.
3. Click <Group…>.
4. Configure the desired parameters and click <OK>.
Note