System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-10 Modem Level – Configuration Menu
Table 3-8. ASMi-52 Data Rates
DTE Interface and Clock Mode Line Interface
Local ASMi-52 Remote ASMi-52 2-wire 4-wire
Serial DTE interface,
internal clock
Serial DTE interface
n × 64 kbps (n = 1, 2, … 32, 36) n × 128 kbps (n = 1, 2, …32, 36)
Serial DTE interface,
external clock
Serial DTE interface
n × 64 kbps (n = 1, 2, …, 36) n × 128 kbps (n = 1, 2, …, 36)
Serial DTE interface E1 DTE interface
n × 64 kbps (n = 3, 4, …, 32) n × 128 kbps (n = 3, 4, …, 16)
E1 DTE interface Serial DTE interface
n × 64 kbps (n = 3, 4, …, 32) n × 128 kbps (n = 3, 4, …, 16)
E1 DTE interface E1 DTE interface
n × 64 kbps (n = 1, 2, …, 32) n × 64 kbps (n = 1, 2, …, 32)
T1 DTE interface T1 DTE interface
n × 64 kbps (n = 1, 2, …, 24) n × 64 kbps (n = 1, 2, …, 24)
Multiplexer Serial/E1 DTE
(any) interface
n × 64 kbps (n = 1, 2, …, 32) n × 64 kbps (n = 1, 2, …, 32)
Table 3-9. ASMi-52 Data Rates (Low Speed Mode)
Unit and DTE Interface Type Line Interface
Local Unit Remote Unit 2-wire 4-wire
ASMi-52 in low
speed mode
n × 64 kbps (n = 1, 2, …, 32) n × 64 kbps (n = 1, 2, …, 32)
ASMi-52 with serial
DTE interface
n × 64 kbps (n = 3, 4, …, 32) n × 128 kbps (n = 3, 4, …, 16)
ASMi-52 in low
speed mode
ASMi-52 with E1
DTE interface
n × 64 kbps (n = 1, 2, …, 32) n × 64 kbps (n = 1, 2, …, 32)
Defining the Time Slot Assignment
The TS Assignment command enables you to define the time slots at the E1 and
T1 port levels.
All time slot values for the FE modem are read-only.

To define the time slot at the E1 and T1 port levels:
1. At the modem level, select Configuration > Bandwidth Allocation…
2. Click TSA... in the E1/T1 field.
3. Configure the desired parameters and click <OK>.
Note