System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
Modem Level – Configuration Menu 3-9
Figure 3-10. Bandwidth Allocation Dialog Box
Table 3-7. Bandwidth Allocation Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Rate
ETH Enabled when a data port is Ethernet.
Select the required data rate from the available values. See
Table 3-8 and Table 3-9 for
the available data rates
DTE Enabled when a data port is Serial DTE.
Select the required data rate from the available values. See
Table 3-8 and Table 3-9 for
the available data rates
In order to increase the possible bandwidth allocation user lower E1/T1 timeslots.
E1/T1 Enabled when a data port is E1/T1.
Select the required data rate from the available values. See
Table 3-8 and Table 3-9 for
the available data rates
TSA Click <TSA> to open the Time Slot Assignments dialog box
Far-End E1 TSs
0...31
This parameter is used to define the time slots when the remote modem is not
connected, or is an ASMi-52 multiplexer unit.
This parameter is available in version 2.5 and above units only.
Set the parameter when the local modem is STU-C and E1 line type is unframed
[Set] Click <Set> to set the modem configuration parameters
[Cancel] Click <Cancel> to close the Modem Parameters dialog box
[Refresh] Click <Refresh> to update the Modem Parameters dialog box