System information

Chapter 3 Configuration Management RADview-EMS ASMi-52 User’s Manual
3-8 Modem Level – Configuration Menu
Table 3-6. Modem Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
Interface Data Traffic
E1/T1 Enable
Checked, Unchecked
DTE Enable
Checked, Unchecked
ETH Enable
Checked, Unchecked
Clock Source
Mode
Internal, External, Receive
Note: This field is read-only for the FE modem
Note: If you lose synchronization between the NE and FE modems (which occurs when
the value for both of them is Receive), change the Receive value for one modem to
another value
Port
E1/T1, DTE
Note: This field is read-only for the FE modem
Wiring
2 Wire, 4 Wire
Note: This field is read-only for a 2-wire modem
Low Speed
No, Yes, 0, ---
Note: This field is disabled only for an NE modem with existing DTE or a LAN connection
Note: This field is read-only if one of the ports has a MUX option or is of type E1/T1
Default Gateway The IP address of the default gateway for the modem
Note: This field is disabled for the FE modem
[Set] Click <Set> to set the modem configuration parameters
[Cancel] Click <Cancel> to close the Modem Parameters dialog box
[Refresh] Click <Refresh> to update the Modem Parameters dialog box
Viewing Available Bandwidth
The Bandwidth Allocation command enables you to view available bandwidth
and define time slot assignments.
This command is not available for an unmanaged FE modem.

To view available bandwidth:
• At the modem level, select Configuration > Bandwidth Allocation…
Note