System information

RADview-EMS ASMi-52 User’s Manual Chapter 3 Configuration Management
Modem Level – Configuration Menu 3-7
Table 3-5. Modem Information Parameters
Parameter Possible Values / Remarks
Location
Near-End, Far-End
SHDSL Mode
STU-C, STU-R
Far-End Modem
Type
Unknown, ASMi-52, ASMi-52 Master, ASMi-52 Slave, ASMi-52/CD, ASMi-52/CQ,
LRS-52, FCD-IP, FCD-IPM, D8SL, MP-SHDSL
SW Version The software version of the modem
HW Version The hardware version of the modem
IP Address The IP address of the modem
[Close] Click <Close> to close the Modem Information dialog box
[Refresh] Click <Refresh> to update the data in the Modem Information dialog box
Configuring the Modem Parameters
The Modem Parameters command enables you to configure the modem
parameters.
This command is not available for an unmanaged FE modem.

To configure modem parameters:
1. At the modem level, select Configuration > Modem Parameters…
2. Configure the desired parameters and click <Set>.
Figure 3-9. Modem Parameters Dialog Box
Note